Date:         Tue, 23 May 1995 11:00:02 EDT
Reply-To:     The NOMAD2 Discussion List
Sender:       The NOMAD2 Discussion List
From:         "Walter H.Horowitz"
Subject:      ANOMAD2 vs. NOMAD2

Raju Pusapati <pusapati@GN2.GETNET.COM> writes:
>Over this weekend we have installed NOMAD 6.02 in MVS environment.  One of
>our applications is invoking  NOMAD by calling ANOMAD2.  I tried to bring up
>this application after install and nothing happened as if MVS ignored the
>command.  We changed the CLIST to call NOMAD2 and now it works.
>
>Before the install we were using NOMAD 5.54.
>
>Any insights into what is use of ANOMAD2?.

The following response came from Frank Griffin:

The NOMAD2 module has a number of special-purpose aliases, and ANOMAD2
is one of them.  The Axxxxxxx aliases are used to define internal-use
entry points employed to run NOMAD2 APF-Authorized.  In general, you
cannot rename NOMAD2 or NOMSYS for testing; the recommended approach
is to create a separate TSO LOGON PROC that uses the test LINKLIB
DSNAME rather than your production LINKLIB DSNAME.


Walter H. Horowitz - email whh@dart.thomsoft.com
Thomson Software Products - (203) 845-5025
back to index